Product Details

• Article Number: 2462S0427 — Ridex standalone ball joint designed as a direct replacement for the pressed-in joint on the BMW X3 F25 front control arm. Allows replacement of just the ball joint instead of the entire control arm assembly — significant cost saving.
• Fitting Position: Front axle, both sides — identical part fits both left and right front positions.
• Cone Size: 23.6 mm — diameter of the tapered stud that engages the steering knuckle/hub carrier. Must match OEM taper exactly for correct seating and torque retention.
• Thread Size: M14×1.5 — metric fine-pitch thread for the securing castle nut. Always use a new nyloc or castle nut when installing.
• Length: 74 mm — overall ball joint length. Critical dimension for correct fitment.
• Height: 83 mm — vertical height of the ball joint body. Combined with length, determines the joint's geometric envelope.
• Condition: New — factory-sealed with pre-packed grease and protective rubber boot.
• Manufacturer: RIDEX — AUTODOC's in-house OEM-equivalent aftermarket brand, produced in IATF 16949 certified factories.
• OEM Cross-References: BMW 31106787665, BMW 6 787 665 — direct equivalents to these original BMW part numbers.
• Vehicle Compatibility: Designed for BMW X3 F25 (2010 onwards) and BMW X4 F26 (2014 onwards). Always verify against your vehicle's VIN or existing part number before purchasing.
• Replacement Recommendation: Worn ball joints cause loose steering feel, clunking noises over bumps, and uneven tyre wear. A failed ball joint can cause loss of steering control — safety-critical component. Requires a ball joint press tool for removal and installation. Always replace in pairs for balanced handling. Wheel alignment required afterwards.
• EAN: 4059191841226

‍